| Article #248 - Why is my terminal beeping after having been configured? |
|---|
| Updated:02-18-2006 - Views: 341 |
| After configuring the 2677m or TC2677, I get a beeping every few seconds with either an active display session or a blank screen with the cursor in the upper left hand corner.
The most likely cause is an address conflict with some other device on the line. Turn off the unit, press and hold the Reset key and power on the unit. Continue to hold the Reset until the configuration screen comes up. Check each display and printer session and make sure only those you intend to configure are active. Make sure any session you do not intend to use is deactivated and any intended session does not have a duplicate address used by another device on the line. |
| Let us know how this article helped you or how it can be improved by submitting a comment. |