| Article #24 - Matrix printer form length problem. |
|---|
| Updated:02-18-2006 - Views: 734 |
| I am having problems getting my matrix printer to top of form properly. My first page prints fine, but each page thereafter prints several inches into the next form.
The print server uses a form length by default of 11 inches. When the host sends a form feed at the end of the page, the print server ejects the page to an eleven inch form. To resolve this issue, go into the configuration utility, click on the AS/400 SCS Printing tab, Advanced, Dot Matrix Printing and change the IBM Motion Commands to Substitute LF for FF and apply the changes. |
|
Use the form below to submit a comment on this article for inclusion into the knowledgebase. End-users are welcome to submit articles relating to any category in the knowledgebase. Submit a comment in response to the knowledgebase article. Please keep the response professional, the content may be modified by the Knowledgebase Administrator. Before posting the comment will be reviewed and may be edited for brevity, structure and content. |