| Article #344 - How do I restore factory defaults on the TC2677 |
|---|
| Updated:02-18-2006 - Views: 544 |
| Recessed in the back side of the TC2677 are two small switches, used as follows:
Switch 1 is normally in the up position. Powering off the TC2677, throwing switch 1 to the down position and powering on the TC2677 will cause the TC2677 to restore factory defaults. With switch 1 in this position, the TC2677 will beep every second or two. Once the TC2677 has completely powered on with switch 1 in the down position, again power off the TC2677, throw switch 1 to the up postion and power on the TC2677. Switch 2 is for either a color or a monochrome CRT. Up selects color and down selects monochrome. Make certain this switch is set correctly or the CRT output may well be unacceptable. |
|
Use the form below to submit a comment on this article for inclusion into the knowledgebase. End-users are welcome to submit articles relating to any category in the knowledgebase. Submit a comment in response to the knowledgebase article. Please keep the response professional, the content may be modified by the Knowledgebase Administrator. Before posting the comment will be reviewed and may be edited for brevity, structure and content. |