| Article #397 - Data not aligning on the form properly when printing through the 4465 |
|---|
| Updated:10-25-2006 - Views: 359 |
|
When printing an overlay, if the data doesn't align properly, a horizontal and/or vertical margin offset will usually align the data on the form. Generally a + or - horizontal offset will move the data right or left, + or - vertical offset will move down or up. This however can change based on the page rotation command within the job. If a particular setting moves the wrong direction you will need to try the other direction or rotation. The offset command is based on 1/60 of an inch, &%I42,-15 will move the data to the left 1/4", &%I43,15 will move the data down on the page 1/4". This is on the assumption the job is printing at a 0 degree page rotation. Once you get the form printing correctly, send down an &%I99,0 to save the setting to nv ram. Sending down the command to the 4465 is accomplished by typing the command on a host command line and doing a print screen, the page should print out on the printer attached to the 4465. |
|
Use the form below to submit a comment on this article for inclusion into the knowledgebase. End-users are welcome to submit articles relating to any category in the knowledgebase. Submit a comment in response to the knowledgebase article. Please keep the response professional, the content may be modified by the Knowledgebase Administrator. Before posting the comment will be reviewed and may be edited for brevity, structure and content. |